A soft or spongy spot in the floor
From the first walkthrough, most manufactured homes are decked in particleboard, which swells and loses its bond once it stays wet.
Homes and commercial properties
Colorado
Our steady-response team removes water and dries lightweight floors, walls, insulation, and underbelly materials commonly affected in mobile homes.
Signs to look for
As we protect the property, if you notice any of these problems, call us before water has more time to spread into nearby materials.
From the first walkthrough, most manufactured homes are decked in particleboard, which swells and loses its bond once it stays wet.
With steady care, panel walls are joined with battens over the seams instead of taped and painted like drywall.
From the first walkthrough, vinyl covered gypsum panel walls sit directly on the decking, so they wick water upward from the floor.
As we protect the property, the seam where two sections join is the most common water entry point on a multi section home.
For dependable recovery, older homes with low slope metal roofs pond water at seams, vents and the edges.
As we protect the property, the furnace and water heater usually share one interior closet sitting directly on the decking.
What happens
Our steady-response team adjusts the work to what got wet, how far the water traveled, and which materials can be saved.
With steady care, we note the home's age, whether it is a single wide or a double wide, and what the deck and the walls are actually made of.
For dependable recovery, particleboard decking that has swelled or lost its bond does not come back, and drying it longer will not change that.
With steady care, panel walls come apart at the battens and the bottom course, which lets us dry the wall cavity without wrecking the whole room.
For dependable recovery, portable extractors and compact submersible pumps come through a 30 inch doorway and up a set of steps.
As we protect the property, many manufactured homes run a 100 amp service, which limits how much drying equipment the home can actually carry.
From the first walkthrough, water that reaches an in floor supply duct sits there and gets blown through every room.
Talk with a restoration specialist
Describe the source, the impacted rooms, and when you first noticed the damage.
What to expect
For dependable recovery, here is how we usually handle mobile home water damage near Colorado.
As we protect the property, tell us the approximate age, whether it is a single wide or double wide, and where the water is showing.
Your callWith steady care, close the fixture valve, or the main at the lot pedestal if it is above ground and safe to reach.
+5 minutesFor dependable recovery, keep people and heavy furniture off any soft area, because wet particleboard loses strength quickly.
+15 minutesFor dependable recovery, we confirm the deck material, the wall panel type, the marriage line if there is one, and where the ducts run.
On arrivalFor dependable recovery, water comes off hard flooring and out of carpet and padding, and contents get lifted and blocked.
First hours on siteAs we protect the property, we tell you which decking sections, wall panels and cabinets are coming out and which are staying.
Same dayAs we protect the property, equipment is placed and the amperage counted before anyone drives away, so your service is not overloaded overnight.
Before we leaveUnderstanding the cost
As we protect the property, we explain the recommended work and price before you approve the job. As we protect the property, these examples show what may change the estimate.
| Common situation | What the estimate may include | Typical range |
|---|---|---|
| One room of a manufactured home, clean water, extraction plus three to four days of drying | With steady care, national estimate. For dependable recovery, a supply line or fixture caught quickly, with little or no decking replacement. | $900 to $2,500 |
| Most of a single wide affected, clean water | With steady care, national estimate. For dependable recovery, includes extraction, padding removal, wall panel bottom course work and five to seven days of equipment. | $3,000 to $8,000 |
| Double wide with several rooms and decking replacement | With steady care, national estimate. As we protect the property, water across the marriage line, two duct runs and significant decking and panel replacement. | $6,000 to $18,000 |
| Particleboard decking replacement, per square foot | As we protect the property, national estimate for removing and replacing failed floor decking, before the finish flooring above it. | $3 to $10 |
| Wall panel replacement, per square foot | With steady care, national estimate for vinyl covered gypsum panel sections including batten work. As we protect the property, older patterns may not be matchable. | $2 to $6 |
| Manufactured home work priced by affected area, clean water | With steady care, national estimate. With steady care, handy once someone has measured the wet area and given you a number. | $3 to $7 per square foot |
| Belly wrap drained, wet insulation out, underbelly repair coordinated | National estimate. Priced and detailed on our under house water removal page, which owns that service plan. | $800 to $3,500 |
| After hours or overnight dispatch charge | With steady care, national estimate. As we protect the property, one charge on the first visit, for nights, weekends and holidays. | $100 to $400 |
What the deck is made of
For dependable recovery, particleboard decking that has swelled has to be replaced, and that is labor plus material plus flooring above it.
How much of the home is wet
With steady care, pricing follows affected square footage.
Single section or multi section
With steady care, a double wide is roughly twice the area and adds the marriage line as both a leak path and a drying boundary.
How clean the water was
With steady care, supply line water is the least damaging case and saves the most material.
Wall panel count
With steady care, panel replacement is priced by area and by how many batten lines have to be opened.
Duct involvement
From the first walkthrough, clearing and drying in floor ducts is straightforward.
Why timing matters
From the first walkthrough, water can keep moving into nearby materials even when the surface looks dry.
With steady care, once the panel swells and its bond fails, it stays swollen and weak no matter how long you dry it.
From the first walkthrough, the vinyl film on these panels is effectively a vapor barrier on the room side, so moisture cannot escape toward the air you are drying.
As we protect the property, small air volume means moisture saturates every room within hours, so there is no comfortable dry side to retreat to.
With steady care, standing water inside a supply duct or the crossover duct gets pushed through the home each time the system runs.
Helpful service information
With steady care, start with the short explanation. From the first walkthrough, open a card if you want a little more detail.
As we protect the property, floors are typically decked in particleboard over relatively shallow floor joists, glued and stapled as a system.
For dependable recovery, manufactured homes are built to the federal HUD Code, which produces a very different set of materials from a site built house.
From the first walkthrough, that film behaves like a vapor barrier on the room side, so moisture in the gypsum core cannot escape toward the dry air you are creating in the room.
As we protect the property, the vinyl face on a panel wall is the detail that catches inexperienced crews.
As we protect the property, a single section home holds a fraction of the air a two story house does, so evaporating water pushes relative humidity up very quickly and evaporation then stalls.
As we protect the property, air volume is the quiet variable in a home this size. As we protect the property, a single section home holds a fraction of the air a two story house does, so evaporating water pushes relative humidity up very quickly and evaporation then stalls.
Help near you
Choose your area below, or call (855) 380-1253 and describe what happened.
You may also need
Our steady-response team removes water from homes, protects belongings, and dries affected rooms after leaks, overflows, storms, or appliance failures.
Get a Quote: (855) 380-1253Our steady-response team removes water beneath the home, clears wet debris or insulation, and dries joists, subflooring, and foundation areas.
Get a Quote: (855) 380-1253Our steady-response team removes surface water and dries moisture trapped beneath finished flooring to protect the subfloor and surrounding materials.
Get a Quote: (855) 380-1253Our steady-response team pumps out crawl-space water, removes wet debris or insulation, and dries framing to control moisture beneath the home.
Get a Quote: (855) 380-1253Our steady-response team removes water, damaged materials, and residue, then cleans and dries affected rooms so repair work can move forward.
Get a Quote: (855) 380-1253Our steady-response team finds moisture inside walls and uses targeted drying or controlled removal to protect framing and nearby finishes.
Get a Quote: (855) 380-1253Our steady-response team addresses water damage in rental properties with clear documentation, moisture readings, and coordinated cleanup for owners, managers, and tenants.
Get a Quote: (855) 380-1253Our steady-response team controls the source, removes water, protects contents, and stabilizes wet materials to prevent avoidable secondary damage.
Get a Quote: (855) 380-1253Common questions
From the first walkthrough, it depends entirely on the deck material. As we protect the property, most manufactured homes use particleboard decking, and once it has swelled or lost its bond it does not recover, so those sections come out.
For dependable recovery, as a national estimate, one wet room with a few days of drying commonly runs $900 to $2,500.
As we protect the property, three reasons. For dependable recovery, the decking is often particleboard rather than plywood, and the walls are vinyl faced gypsum panels joined with battens rather than taped drywall.
With steady care, the bottom few inches are usually the problem, because panels sit on the deck and wick water upward.
For dependable recovery, that is a separate service plan from the work inside your home, and our under house water removal page covers it in full.
With steady care, extraction usually finishes in one to three hours. As we protect the property, drying then takes about three to five days for a typical loss, sometimes less because there is less material.
With steady care, yes, and it is one of the most commonly missed steps. With steady care, supply ducts run inside the floor and the crossover duct links the sections on a double wide, so water sits in them and gets blown through the home.
Talk with a restoration specialist
Describe the source, the impacted rooms, and when you first noticed the damage.
Areas we serve
Our steady-response team carefully review homes, businesses, and managed properties throughout Colorado and nearby communities.
View the area on Google Maps